Announcement

Collapse
No announcement yet.

Fitting a new propshaft U/J

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fitting a new propshaft U/J

    I've fitted a new U/J to the rear end of my propshaft. All was going well but it seems to be quite stiff compared with the old one. It moved freely until I fitted the circlips that retain the cups. Is the normal?
    Mk2 SWB Marina Roadster with a 2.0L Pinto built in 1986

  • #2
    Re: Fitting a new propshaft U/J

    Just give it a tap to settle the cups back against the circlips. Should then be free.

    Comment


    • #3
      Re: Fitting a new propshaft U/J

      Thanks, I'll give it a try in the morning
      Mk2 SWB Marina Roadster with a 2.0L Pinto built in 1986

      Comment


      • #4
        Re: Fitting a new propshaft U/J

        That did the trick
        Mk2 SWB Marina Roadster with a 2.0L Pinto built in 1986

        Comment


        • #5
          Re: Fitting a new propshaft U/J

          Simples!

          Comment


          • #6
            Re: Fitting a new propshaft U/J

            I'm doing a 60 mile run with the SKCC in the morning if I can get out of bed... it starts at 7!
            Mk2 SWB Marina Roadster with a 2.0L Pinto built in 1986

            Comment

            Working...
            X