Announcement

Collapse
No announcement yet.

Circlip

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Circlip

    Message originally posted by: Worried
    Having spotted a little rust on the circlip that locates the retaining spigot on the transverse locating bush on the off side I decided to replace it. However I seem to recall that when I looked at he prototype on the stand at the Kitcar show that the open end of the circlip faced the rear of the car. I have found it easier to replace it with the open end facing the front. will this affect the performance and security of the clip?

  • #2
    Re: Circlip

    Message originally posted by: Confused
    Give us a clue ?

    Comment


    • #3
      Re: Circlip

      Message originally posted by: Knowall
      As long as the bifurcated ninge wheel does not lock it's spigot in reverse ratchet mode you might be OK. Watch out for MoT though!

      Comment


      • #4
        Re: Circlip

        Message originally posted by: Someone
        Hmmmm, definitely a case for closing the Modified page I think...

        Comment


        • #5
          Re: Circlip

          Message originally posted by: cautious
          then again mabe that circlip is the one holding it all together!!!! better put it back as it was

          Comment


          • #6
            Re: Circlip

            Message originally posted by: Anita
            I always use a hairclip.

            Comment

            Working...
            X