Announcement

Collapse
No announcement yet.

I'd never make a quick fit fitter at this rate !

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • I'd never make a quick fit fitter at this rate !

    Into my garage for a bit more aggro, ( Bad neck) Measured up the new silencer position , then fabricated two new exhaust hangers from 10mm bar and welded them in place, it took a while to get back into stick welding, my old rods had deteriorated, the flux fell off the Orlicon rods, but I found some 2mm rods with a blue flux on them, I think they were my old dissimilar rods, they were ok too, I just needed a bit more ampage from my Micky mouse welder and we were away ( Little carpet fire, not in the car ! ) then cleaned up the area and applied a lick of Hammerite. The ebay man who sent me the wrong size exhaust brackets was very apologetic and soon sent me another set -- er, also the wrong size, so I'll wait till I'm in town and pick up a pair then, so thats it !
Working...
X