Announcement

Collapse
No announcement yet.

Fitting a genuine Marlin stainless steel badge

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Fitting a genuine Marlin stainless steel badge

    Yes I went ahead and bought one and notice that the mounting studs are offset that is if I drill two holes on the horizontal the word Marlin will be slanted. I was expecting this but just want to check that this is correct before I drill two holes in my rear body shell.

    thanks,

    David.
    - 9th owner of T693 SSC possibly a factory built Ford based V8 Sportster
    - 4th owner of Q309 RNV, an early Cabrio built by Bob Copping, owned Doug & Liz Billings for 16 years
    - 9th Custodian of JRR 929D, Triumph Vitesse based special Paul Moorehouse built prior to the Triumph Roadster kits.
    - 8th owner of Roadster chassis number 2395. Now owned by Barry!
    - Builder of chassis number 2325 (PKK 989M) in the mid 80's. Now owned by Eric & Lynne.
Working...
X