Click here to sign up  Click here to go to the galleries  Click here to go to the code of conduct  Click here to go to the video page  Click here to go to the SW Meets page

Search:

Type: Posts; User: chris_cussen

Page 1 of 27 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    7
    Views
    881

    Re: Speed prop speed sensor

    Same solution as Paul using an ETB speedo which can be programmed to show the correct speed by setting the number of counts per mile.
  2. Re: So I thought I might still have one more project in me..........

    CAD = Cardboard Aided Design.
    Very useful
  3. Replies
    4
    Views
    818

    Re: Brake Judder

    Standard Sierra discs are cheap as chips, and the pads not expensive either. Try changing them both. I run the standard setup and can lock up the front wheels if I try hard. Anything above the...
  4. Replies
    6
    Views
    960

    Re: New Member in Sheffield

    The IVA manual is avaialble here: https://www.gov.uk/government/publications/iva-manual-for-vehicle-category-m1
    My Cabrio was the first to pass IVA in 2009 when it came into force. All I can suggest...
  5. Replies
    7
    Views
    956

    Re: Seriously Exhausted?

    Ah Well yes, good question Bill.
    When I had the DOHC engine in the exhaust ran under the floorpan and then there was a large twin pipe exhaust box tucked up under the fuel tank and the exhaust...
  6. Replies
    33
    Views
    2,752

    Re: Cabrio engine keeps stopping

    Does it have an ignition coil? I have had one breakdown when hot.
    Basic test, carry a spare spark plug. when it stops disconnect an ignition lead and connect it to the sparkplug. make sure the body...
  7. Replies
    1
    Views
    510

    Re: Powderham Castle

    Didn't know about the event. Shame!
  8. Replies
    9
    Views
    1,315

    Re: Another quirky electrical question

    Got there in the end Bill, well done.
    Multiple faults are always a b*****r.
  9. Thread: Ping!

    by chris_cussen
    Replies
    4
    Views
    793

    Re: Ping!

    After the Ping incident I completed the job on the nearside and a couple of days ago did the offside.

    That had a hiccup too, one of the 4 bolts holding the hub carrier to the trailing arm was not...
  10. Replies
    9
    Views
    1,315

    Re: Another quirky electrical question

    Sometime two faults occur at the same time.
    Have you put the hazard flashers on to see if the bulbs illuminate then?
  11. Re: paint colour , shot in the dark request

    I seem to remember that when Marlin built their one off Makeria(sic) it was painted to match the oweners nail varnish. (Of course I might of had a weird dream)
    But Marlin painted cars in whatever...
  12. Thread: Ping!

    by chris_cussen
    Replies
    4
    Views
    793

    Re: Ping!

    Spent an hour searching next doors flowerbed. Don't think a magnet would have helped. Replacement parts for a set of 4 cost £4.99 and were ordered on Sunday and arrived today.
  13. Thread: Ping!

    by chris_cussen
    Replies
    4
    Views
    793

    Ping!

    Having been given several packets of shims by Bill Jackson and being told about the necessary thickness required to align the rear wheel tracking on my Cabrio I sat on the drive in the sunshine and...
  14. Replies
    6
    Views
    2,009

    Re: build manual cabrio anyone

    PM your address and I will put one in the post.
  15. Replies
    6
    Views
    945

    Re: Throttle cable linkage problem

    Hi Bill,
    I did PM you, but this supersedes the PM.
    The final location of my Zetec throttle cable is very similar to the DOHC engine. I have higlighted the cable with arrows in the pictures.
    I am...
  16. Replies
    4
    Views
    762

    Re: Cabrio heater motor

    Can't remember the full details but the heater motor is under a firbreglass cover inside the engine bay just in front of the windscreen and behind the battery. It all depends on how the builder...
  17. Re: Reattaching the offside front cycle wing...

    I have used this kind of bolt 12793 extensively to attach bumpers, wings and down the centre line of the bonnet.
    Search eBay for Button Headed bolts and buy stainless versions and nuts, they won't...
  18. Summer Solstice Vintage Vehicle Gathering - Gillingham Dorset 21st June

    12769
  19. Replies
    4
    Views
    975

    Re: Alternative Alternator?

    No Problem, that is why we belong to the club.
  20. Replies
    4
    Views
    975

    Re: Alternative Alternator?

    Bill,
    I think I have a surplus alternator in the shed, but I am off to help at Navy Wings today, so I'll check when I get home. You are welcome to have it if I can find it as it is from my old DOHC...
  21. Replies
    4
    Views
    1,982

    Re: pinto engine head bolts

    The torx bolts are the ones that need to be turned another 90 degrees after getting to the tightening torque, and therefore stretch. Having stretched them they are not re-useable. Listed here:...
  22. Replies
    287
    Views
    253,186

    Sticky: Re: What have you done with your marlin today

    Quik whizz down the A303 to Yeovilton this morning to where I help at "Navy Wings", who maintain the FAA historic flight. Up today was a DH82 and one of the two airworthy Seafires SX336 who did flew...
  23. Replies
    13
    Views
    2,430

    Re: Berlinetta sierra battery

    Might seem like a stupid idea, why not measure the space and visit a motor factors with the dimensions. If they are any good then they can help you get one that fits in the space. if they can't/won't...
  24. Replies
    3
    Views
    981

    Re: rear tail lights for marlin roadster

    I fitted these to a Cabrio...
  25. Replies
    6
    Views
    1,459

    Re: Chassis plate

    I bought a set of alpha/numeric punches and stamped the chassis number on the top of the offside scuttle. It satisfied the IVA examiner at the time (2009), although he thought the IVA rules governing...
Results 1 to 25 of 672
Page 1 of 27 1 2 3 4