Announcement

Collapse
No announcement yet.

Headlamp Bar

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Headlamp Bar

    If anyone is interested, my local engineering workshop will make a stainless (316 grade - better quality to resist salt corrosion)headlamp bar, with laser cut ends and headlamp mounts for £65 each.
    I can vouch for the quality being very good, but polishing will be left to you. This is easy enough if you buy a polishing kit and are prepared to get dirty! The finish can be brought up to chrome standards quite easily. If you want extra headlamp fixings, this can easily be accommodated too, just provide details on a sketch.
    If anyone is interested, please contact me via email:
    Mands(dot)garner(at)btinternet(dot)com or call on 01775 680450

  • #2
    Re: Headlamp Bar

    Hi all

    There are at least a couple of people interested in the stainless light bar, and possibly bumpers too. Rather than get them to do these specials as one offs, I would like to consolidate them into one job lot.
    If anyone is interested, could you please let me know by mid September.
    Regards to all
    Mike

    Comment


    • #3
      Re: Headlamp Bar

      I'd be interested in Roadster bumpers...

      Comment


      • #4
        Re: Headlamp Bar

        What do they look like then.............?

        Comment


        • #5
          Re: Headlamp Bar

          Chrome Bumpers for a Roadster, sounds interesting.

          I could be interested in some of those.

          Don't need a headlamp bar with cycle wings though.

          Neil.

          Comment


          • #6
            Re: Headlamp Bar

            Hope the attached photos are of interest?
            Attached Files

            Comment

            Working...
            X