Announcement

Collapse
No announcement yet.

Morris Marina 1.3 engine sump

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Morris Marina 1.3 engine sump

    Hi All

    Does anyone have a engine sump for a 1.3 morris marina engine?

    Regards

    Adrian

  • #2
    Re: Morris Marina 1.3 engine sump

    That took some damage too. It does sit lower that the chassis so suppose it is vulnerable.
    How much damage in total?

    Comment


    • #3
      Re: Morris Marina 1.3 engine sump

      Originally posted by listerjp2 View Post
      Hi All

      Does anyone have a engine sump for a 1.3 morris marina engine?

      Regards

      Adrian
      If it has had a good whack check the engine and gearbox mountings haven’t split.

      Not familiar with that engine but also check no damage to oil pick up pipe, filter or oil pump. Peter.

      Comment


      • #4
        Re: Morris Marina 1.3 engine sump

        Not looked myself at the moment but it is supposed to have a split in it.

        Adrian

        Originally posted by meverett View Post
        That took some damage too. It does sit lower that the chassis so suppose it is vulnerable.
        How much damage in total?

        Comment


        • #5
          Re: Morris Marina 1.3 engine sump

          Will do.

          Adrian

          Originally posted by greyV8pete View Post
          If it has had a good whack check the engine and gearbox mountings haven’t split.

          Not familiar with that engine but also check no damage to oil pick up pipe, filter or oil pump. Peter.

          Comment


          • #6
            Re: Morris Marina 1.3 engine sump



            any good?

            Blast, just seen it's gone

            Comment


            • #7
              Re: Morris Marina 1.3 engine sump

              Is it alloy or steel? Will it press out and weld up?

              Comment


              • #8
                Re: Morris Marina 1.3 engine sump

                Hiya

                Was thinking that just thought less hassle and quicker would be to replace it.

                Now finding that they are fairly rare, so will look at it first and maybe take it to a bloke I know called metal micky.

                Regards

                Adrian

                Originally posted by h_m_cumming View Post
                Is it alloy or steel? Will it press out and weld up?

                Comment


                • #9
                  Re: Morris Marina 1.3 engine sump

                  Would it be the same as this one
                  Ben Caswell probably not the last word on anything here!!

                  Comment


                  • #10
                    Re: Morris Marina 1.3 engine sump

                    That's the one I was looking at in #6 above. Been relisted.

                    Comment


                    • #11
                      Re: Morris Marina 1.3 engine sump

                      Will this fit the 1275 a+ engine ?

                      Adrian


                      Originally posted by h_m_cumming View Post
                      That's the one I was looking at in #6 above. Been relisted.

                      Comment


                      • #12
                        Re: Morris Marina 1.3 engine sump

                        I think the A+ used a rubber seal gasket each end (flywheel and pulley) , the A used cork gaskets. Don’t think the block is different so should fit.
                        It is steel so could be welded.

                        Comment

                        Working...
                        X