YKC roadster, 2.0 Pinto with DGAV carb: I have just replaced the throttle cable as it was fraying and breaking at the carb end. On removing it I found the inner cable very frayed and broken inside the sleeve at the sharp bend where it has to bend back by the carb to clear the bonnet side panel. It really is a very sharp bend.
Has anyone fitted a different throttle linkage to cure this, or even is it possible to turn the carb 180 so the cable runs directly over the top of the engine with only a 90 degree bend instead of the 270 one it does now?
Has anyone fitted a different throttle linkage to cure this, or even is it possible to turn the carb 180 so the cable runs directly over the top of the engine with only a 90 degree bend instead of the 270 one it does now?
Comment