Click here to sign up  Click here to go to the galleries  Click here to go to the code of conduct  Click here to go to the video page  Click here to go to the SW Meets page

Thread: Marlin Cabrio - hood seal

Results 1 to 4 of 4
  1. #1 Marlin Cabrio - hood seal 
    regular forum contributor Club Member
    Join Date
    Jul 2018
    Posts
    11
    Does anyone have experience of fixing leaking soft tops? The hood on my Marlin Cabrio has a defective seal where it closes onto the windscreen - the current seal is made up of a double layer of rubber piping and I have been told by the resident soft top expert at the Morris Minor centre in Bristol that there should be a better type of seal available to use. He is willing to make the repair but has left it to me to find the correct seal. I have written to Terry at Marlin, but she is on holiday until 22/07 so I thought that maybe someone else can recommend the correct product to use?
    Reply With Quote  
     

  2. #2 Re: Marlin Cabrio - hood seal 
    frequent forum contributor Club Member chris_cussen's Avatar
    Join Date
    Nov 2011
    Location
    South Somerset
    Posts
    498
    Dunno-but if you find out please share!
    Cabrio, Omex 2.0l 150bhp Zetec blacktop, Omex ECU and wiring loom.
    Reply With Quote  
     

  3. #3 Re: Marlin Cabrio - hood seal 
    frequent forum contributor Club Member
    Join Date
    Nov 2016
    Posts
    57
    I think the original idea was closed cell foam strip of maybe 3mm x 20mm bonded to the forward edge of hood, full width. Other members have used 'D' section rubber again full width and either side of the securing pegs. They can be obtained in various sizes from Woolies or Seals Direct
    Reply With Quote  
     

  4. #4 Re: Marlin Cabrio - hood seal 
    frequent forum contributor Club Member
    Join Date
    Jan 2016
    Location
    Rugby
    Posts
    201
    Quote Originally Posted by A_Hogg View Post
    I think the original idea was closed cell foam strip of maybe 3mm x 20mm bonded to the forward edge of hood, full width. Other members have used 'D' section rubber again full width and either side of the securing pegs. They can be obtained in various sizes from Woolies or Seals Direct
    When mine needed replacing I used this:

    https://www.carbuildersolutions.com/...trip-per-metre

    As mentioned above this is bonded to the forward edge of the hood. I ran two pieces side by side to give a good width and its a nice snug fit. Not had any issues with water ingress.
    2000 Marlin Cabrio; 2.0 L Burton Pinto in Ford Nightfire Red with Magnolia leather interior.

    http://www.marlinownersclub.com/wppg...&image_id=2349
    Reply With Quote  
     

Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •