Hi Guys
The Marina steering rack on my kit had the usual worn bush clonk - not going to pass its WOF
I have taken the old bush out - its a steel case with a plastic bearing bit
unfortunately no longer completely round so difficult to measure the OD
SO
Ideally I would buy a new bush
But that looks to be unlikely
So I will get one machined
The ID will be to suit the rack
The OD is the question - it appears to be 1.20 inches
Anybody know what the OD should be??
The hole it goes into is a pain as it has three slots machined in it 120 degrees apart making measuring the diameter a bit more difficult
Can anybody help
Please
The Marina steering rack on my kit had the usual worn bush clonk - not going to pass its WOF
I have taken the old bush out - its a steel case with a plastic bearing bit
unfortunately no longer completely round so difficult to measure the OD
SO
Ideally I would buy a new bush
But that looks to be unlikely
So I will get one machined
The ID will be to suit the rack
The OD is the question - it appears to be 1.20 inches
Anybody know what the OD should be??
The hole it goes into is a pain as it has three slots machined in it 120 degrees apart making measuring the diameter a bit more difficult
Can anybody help
Please
Comment